IfMetal Detector BrandThe sensitivity of the manufacturer's metal detector cannot meet the requirements of customers, and the sensitivity of the metal detector can be improved. If the metal detector of the metal detector brand can detect the test card, it will sound an alarm and shut down normally.

For the metal detector of the used metal detector brand, soak the long cloth (towel) with alcohol, adjust the sensitivity to a lower level, start the machine, press down any end of the conveyor belt with a long strip, wipe the dirt in front of the conveyor belt, and let The conveyor belt runs several times until there is no dirt on the conveyor belt, then stop, clean the long cloth and wring it dry, try to pass the long cloth through the belt (reverse side) under the belt, grasp the two parts of the belt with each hand, and then start the machine to clean the dirt on the back of the belt.

The sensitivity of the metal detector of the manufacturer of the metal detector brand is the diameter of the standard test card used. The sensitivity of the actual food metal detector brand metal detector should be determined according to the type of test card, which depends on the specific product being tested and the height of the passage in and out of the food metal detector. The sensitivity verification of the above metal detectors needs to be performed every three to four hours, and the verification results are recorded for customer inspection.

Metal Detector BrandThe manufacturer's metal detectors can be widely used in the food, pharmaceutical, chemical, plastics and other industries. Every industry has different product and testing requirements. Therefore, it is very necessary to choose a metal detector suitable for the industry.

The food industry has many subcategories. In terms of product status, there are usually two types of products: dry products and wet products. Dry products without water are easier to detect. When selecting a device type, use the regular product. According to the shape of the product, choose the right model. In general, small bags of food (such as bread, biscuits and candy) can be used as a conveyor metal detector for the assembly line. It is placed at the back of the production process and put into storage directly after passing the inspection. For dry and powdery products, you need to choose a falling metal separator to classify unqualified products through automatic separation equipment. The opening of the metal detector of the metal detector brand is very small, and the detection sensitivity is relatively high compared with the transmission type.

Wet products are more difficult to detect than dry products. The moisture content in wet products, one of the characteristics of water is conductivity. The problem of salt and sugar reappears when analyzing the wet product formed by the packaging. One class of wet products are pure liquids, pastes and pastes. Such products will have to choose a pipe metal detector and use a pump to provide pressure to push the product through the inspection. For pure liquid products, set the pressure parameters of the pump during the test, because the over-test speed should be consistent with the reaction time of the detection probe.